Camera AI vs. Loop Timers
Loop timers detect a car at a few fixed points in the pavement. Hellometer’s cameras see the whole lane, so you know where the time actually goes.
The Problem With Loop Timers
Most drive-thru timer systems rely on pressure loops embedded in the pavement or simple pole sensors. These systems detect vehicle presence but tell you almost nothing about what’s actually happening in the lane.
They can’t distinguish between a car waiting to order and a car stuck behind a slow transaction. They can’t see when the kitchen is backed up or when a crew member steps away from the window. The result: operators get a single number, average service time, that obscures more than it reveals.
What Cameras See Instead
Hellometer detects and tracks every vehicle from the moment it enters your drive-thru lane and follows it through every station: order point, payment window, and pickup. You get a second-by-second timeline of each transaction.
There is no road cutting, no sensor maintenance, and no recalibration. The system adapts to lane changes, dual-lane setups, and stacked queues.
One System, More Than the Lane
The same cameras also time the lobby from door to dine, monitor the kitchen, and flag loss, so a single-purpose timer becomes one camera system for the whole location.
At a Glance
| Compared | Loop timers | Hellometer |
|---|---|---|
| How cars are detected | Pressure loops embedded in the pavement, or pole sensors | Cameras and computer vision |
| What is measured | Vehicle presence at fixed points | Every car through order, pay, and pickup |
| Installation | Sensors set into the pavement | Cameras, installed in hours with no road cutting |
| Beyond the drive-thru | Drive-thru only | Lobby, kitchen, and loss prevention on the same cameras |
Frequently Asked Questions
Can Hellometer replace our loop timer?
Yes. Hellometer times every car with cameras instead of sensors in the pavement, with no road cutting, no sensor maintenance, and no recalibration.